Configure Discrete Output Source - Emerson Micro Motion 2700 Configuration And Use Manual

6.4.1

Configure Discrete Output Source

Display
ProLink III
Field Communicator Configure > Manual Setup > Inputs/Outputs > Discrete Output > DO Assignment
Overview
Discrete Output Source controls which device condition or process condition is reported
via the Discrete Output.
Procedure
Set Discrete Output Source to the desired option.
The default setting for Discrete Output Source is Flow Direction.
Options for Discrete Output Source
Option Display
(1)
D EV x
Discrete Event 1–5
(2)
Event 1–2 EVNT1
EVNT2
E1OR2
Flow Switch FL SW
Flow Direction FLDIR
Calibration in Pro- ZERO
gress
Fault FAULT
(1) Events configured using the enhanced event model.
(2) Events configured using the basic event model.
Configuration and Use Manual
OFF-LINE MAINT > OFF-LINE CONFG > IO > CH B > SET DO > DO SRC
Device Tools > Configuration > I/O > Outputs > Discrete Output
Label
Field Communi-
ProLink III cator
Enhanced Event 1
Discrete Event x
Enhanced Event 2
Enhanced Event 3
Enhanced Event 4
Enhanced Event 5
Event 1
Event 1
Event 2
Event 2
Event 1 or Event 2
Event 1 or Event
Status
2
Flow Switch Indicator Flow Switch
Forward Reverse In- Forward/Reverse
dicator
Calibration in Pro- Calibration in Pro-
gress
gress
Fault Indication Fault
Integrate the meter with the control system
Discrete Output
State voltage
ON Site-specific
OFF 0 V
ON Site-specific
OFF 0 V
ON Site-specific
OFF 0 V
Forward flow 0 V
Reverse flow Site-specific
ON Site-specific
OFF 0 V
ON Site-specific
OFF 0 V
103