Overview Of Zones With Active Fire Pre-Alarms - Honeywell H-S81-HS Operation Manual

Operating Instructions
This page shows:
• The total number of alarmed zones
• The name and number of the first alarmed zone
• The name and number of the first sensor of the alarmed zone.
• The current number and the total number of alarmed zone sensors.
The complete list of alarmed sensors can be viewed by using the Scroll button.

7.4.4 Overview of Zones with Active Fire Pre-alarms

The overview of zones with active fire pre-alarm is the same as that of the zones with active fire
alarms.
7.4.5 Overview of Zones Under Supervisory Condition
The overview of the zones under "supervisory" condition is the same as that of the zones with
active fire alarms.
7.4.6 Overview of Zones with Active Gas Alarm
The overview of the zones with active gas alarms is the same as that of the zones with active fire
alarms.
7.4.7 Overview of Trouble Zones
The overview of the trouble zones is the same as that of the zones with active fire alarms.
7.4.8 Overview of System Faults
In case of one or more system faults, the following page will be displayed.
In case of several different events, the sequence of all event pages can be seen by pressing Esc. In
all cases, after one minute of idle time, the system will display the page with the alarms with higher
priority. During this stage, any new events having higher priority will be immediately shown on the
display. The presence of events with lower priority will be signaled as shown in the picture below.
134
Figure 7.6 System Faults
H-S81-HS Installation & Operation Manual — P/N LS10114-000HI-E:A 2/24/2015
Operations at Access Level 1