Multicast Vlan Registration Commands - SMC Networks 7824M/FSW - annexe 1 Management Manual

Example
The following shows that port 11 in VLAN 1 is attached to a multicast
router:
Console#show ip igmp snooping mrouter vlan 1
VLAN M'cast Router Ports Type
---- ------------------- -------
1
Console#

Multicast VLAN Registration Commands

This section describes commands used to configure Multicast VLAN
Registration (MVR). A single network-wide VLAN can be used to transmit
multicast traffic (such as television channels) across a service provider's
network. Any multicast traffic entering an MVR VLAN is sent to all
subscribers. This can significantly reduce to processing overhead required
to dynamically monitor and establish the distribution tree for a normal
multicast VLAN. Also note that MVR maintains the user isolation and data
security provided by VLAN segregation by passing only multicast traffic
into other VLANs to which the subscribers belong.
Command
mvr
mvr
show mvr
M
Eth 1/11
Table 33-5 Multicast VLAN Registration Commands
Function
Globally enables MVR, statically configures MVR
group address(es), or specifies the MVR VLAN
identifier
Configures an interface as an MVR receiver or
source port, enables immediate leave capability, or
configures an interface as a static member of the
MVR VLAN
Shows information about the global MVR
configuration settings, the interfaces attached to the
MVR VLAN, or the multicast groups assigned to
the MVR VLAN
VLAN R
ULTICAST
Static
C
EGISTRATION OMMANDS
Mode Page
GC
IC
PE
33-16
33-17
33-19
33-15