When User Range Setting Is Used And Initial Setting Was Made With Gx Configurator-Ti (Other System Is Unavailable) - Mitsubishi Melsec-Q Series User Manual

7
ONLINE MODULE CHANGE
7.3.4 When user range setting is used and initial setting was made with
GX Configurator-TI (other system is unavailable)
(1) Conversion disable
7.3.4 When user range setting is used and initial setting was made with GX Configurator-TI (other system
(a) Set "Disable" in the Setting value field of Conversion Enable/Disable Setting on
the CH Monitor/Test screen of GX Configurator-TI, and click the
Execute test button.
Figure 7.33 "CH
(b) After making sure that "Disable" is displayed in the Current value field of
Conversion Enable/Disable Setting, set "Request" in the Setting value field of
Operation Condition Setting Request on the Monitor screen, and click the
button to stop conversion.
Monitor the Conversion Completion Flag (Un\G10) and confirm that conversion
has stopped.
Figure 7.34 Conversion Completion Flag check
Monitor/test" screen
7.3 Online Module Change Procedure
1
2
3
4
5
6
7
8
7
- 18