Ch[ ] Conversion Setting Value For Disconnection Detection (Un\G166 To Un\G173); Ch[ ] Conversion Setting Value For Disconnection State (Un\G166 To Un\G173) (Q68Td-G-H01Only) - Mitsubishi Melsec-Q Series User Manual

3
SPECIFICATIONS
3.4.27
When "Give value" (2
(Un\G164,Un\G165), the value to be stored into CH
(Un\G11toUn\G18) can be set by user. (Refer to Section 3.2.2)
(1) Setting methods
(2) Default value
[Setting example] When the value of 800
value for disconnection detection.
3.4.28
When "Give value" (2
(Un\G164,Un\G165), the value to be stored into CH
(Un\G11toUn\G18) can be set by user in the disconnection state check. (Refer to Section
3.2.3)
(1) Setting methods
(2) Default value
[Setting example] When the value of 800
value for the check of disconnection state
3
3.4 Buffer Memory
- 58
3.4.27 CH[ ] Conversion setting value for disconnection detection (Un\G166 to Un\G173) (Q68TD-G-H02
CH[ ] Conversion setting value for disconnection detection
(Un\G166 to Un\G173) (Q68TD-G-H02 only)
) is set in Conversion setting for disconnection detection
H
(a) Set the value to be stored in buffer memory in units of 0.1
• Settable range:-32768 to 32767
(b) Turn on Operating condition setting request (Y9) to activate the setting.
All channels are set to "0".
1) Set the following in buffer memory.
• Conversion setting for disconnection detection (Un\G164):2
• CH1 Conversion setting value for disconnection detection(Un\G166):8000
2) Turn on Operating condition setting request (Y9).
CH[ ] Conversion setting value for disconnection state
(Un\G166 to Un\G173) (Q68TD-G-H01only)
) is set in the Disconnection state conversion setting
H
(a) Set the valuetobe stored in buffer memory in units of 0.1
• Settable range:-32768 to 32767
(b) Turn on Operating condition setting request (Y9) to activate the setting.
All channels are set to"0".
1) Set the following in buffer memory.
• Disconnection state conversion setting (Un\G164):2
• CH1 Conversion setting value for disconnection state (Un\G166):8000
2) Turn on Operating condition setting request (Y9) to activate the setting.
Measured temperature value
is stored into CH1 Measured temperature
Measured temperature value
is stored into CH1 Measured temperature
.
H
.
H