Using Programs On Remote I/O Network - Mitsubishi Melsec-Q Series User Manual

6
PROGRAMMING
6.3

Using Programs on Remote I/O Network

This section describes programs examples based on the following system configuration
and conditions.
(1) System configuraton
Remote master station (Station No.0)
(2) Setting conditions for the intelligent function module switch setting
6
- 15 6.3 Using Programs on Remote I/O Network
QJ71LP21-25(X/Y0 to X/Y1F)
QX10(X20 to X2F)
QY10(Y30 to Y3F)
Network No.1
Figure 6.17 System configuratiion using remote I/O network
Table 6.6 Setting conditions for the intelligent function module switch setting
Thermocouple type
CH1
CH2 Thermocouple type K
CH3
CH4
to Not used
CH8
Based on the above conditions, perform the intelligent function module switch setting.
Click the switch setting button on the "I/O assignment" tab of PLC parameter in GX
Developer to display the following screen, and make settings of values described in
the following table.
Table 6.7 Description of Intelligent function module switch setting
Switch number
Switch 1 0000
Switch 2 0000
Switch 3 0000
Switch 4 0000
Switch 5 0000
Remote I/O station (Station No.1)
Q68TD-G-H02(X/Y1000 to X/Y100F)
QJ72LP25-25
Offset/gain setting
Factory default setting
Setting value
(CH1 to CH3: Thermocouple K)
H
(CH4 to CH8: Default)
H
(CH1 to CH3: Factory default setting, CH4 to CH8: Default)
H
(Cold junction compensation YES, Normal mode)
H
(0: Fixed)
H
Cold junction
compensation
Available
- -