Offset/Gain Setting Operation - Mitsubishi Melsec-Q Series User Manual

5
UTILITY PACKAGE (GX Configurator-TI)
5.6.2

Offset/gain setting operation

Perform the offset/gain setting operation in the following sequence.
(1) Display the "CH
Display the "CH
setting will be made using the operation described in Section 5.6.1.
(2) Switch to the offset/gain setting mode
Note) Do not perform this operation when the setting has been changed
to the offset/gain setting mode.
Set "Offset/gain setting mode" in the Setting value field for "Mode Switching Setting
"and click the
Switching Setting Status" changes to "Offset/gain setting mode".
(3) Enable the Conversion enable/disable setting
(a) Set "Enable" in the Setting value field for "Conversion enable/disable setting" and
(b) Set "Request" in the Setting value field for "Operating condition setting request"
(c) Set "OFF" in the Setting value field for "Operating condition setting request"
(4) Adjustment of the offset and gain values
(a) Adjust the offset setting value
Offset/gain setting" screen
Offset/gain setting" screen of the channel where offset/gain
button. The indication in the Current value field of "Mode
click the button.
setting and click the
changes from "OFF" to "Request".
setting and click the
changes from "Request" to "OFF".
1) Select the offset setting
Select "Offset setting" in the Setting value field for "CH
setting" and click the
2) Set the offset value
Enter the desired value into the Setting value field for "CH
temperature setting value", and click the
3) Determine the offset value
Select "Request" in the Setting value field for "CH
setting and click the
Confirm that "CH Channel change completion flag" has changed to
"Completed", and then select "OFF" in the Setting value field of "CH
change request" and click the
Select "Invalid" in the Setting value field for "CH
setting" and click the
button. The indication in the Current value field
button. The indication in the Current value field
button.
button.
Channel change request"
button.
button.
Offset setting channel
button.
5.6 Monitoring/Test
5.6.2 Offset/gain setting operation
Offset setting channel
Offset
Channel
5
- 21
1
2
3
4
5
6
7
8