Omc (Online Module Change) Refresh Data - Mitsubishi Melsec-Q Series User Manual

5
UTILITY PACKAGE (GX Configurator-TI)
5.6.3

OMC (Online Module Change) refresh data

Perform operation in the following sequence to save/restore the user range.
(1) Switch to the OMC refresh data screen
Perform the operation in Section 5.6.1 to display the OMC refresh data screen.
(2) User range saving
(a) Change the Setting value field of Online Module Change read request to
(b) Compare the values with those in the range reference table, and take a note of the
(3) User range restoration
(a) Set the noted values into the Setting value fields of CH
(b) Select all the Setting value fields of CH
(c) Change the Setting value field of online module change write request to
Figure 5.12 OMC data
"Request", and click the
When read is completed, the values are displayed in the Current value fields of
CH Factory default offset/gain value/User range settings offset/gain value/User
range settings offset/gain thermal EMF value.
values if they are correct.
Refer to Section 7.4 for the range reference table.
gain value/User range settings offset/gain value/User range settings thermal EMF
offset/gain value.
User range settings offset/gain value/User range settings thermal EMF offset/gain
value, and click the
When write is completed, the set values are displayed in the Current value fields
of them.
"Request", and click the
Make sure that the indication in the Current value field of online module change
write request changes from "Request" to "OFF" on completion of write.
5.6.3 OMC (Online Module Change) refresh data
button.
Factory default offset/gain input value/
button.
button.
5.6 Monitoring/Test
Factory default offset/
5
- 23
1
2
3
4
5
6
7
8