Edit An Existing Location - Uniden BCD996XT User Manual

ProgrammingLocations < UnidenMan4 < TWiki
In addition to range, you can specify a heading and a speed limit for these types of locations:
If you set a speed limit, the scanner will only trigger an alert when you are within the
location's range and your current speed is over the programmed speed limit.
If you set a heading, the scanner will only trigger an alert when you are within the
location's range and your current heading is +/- 45 degrees from the programmed
heading. (For example, if you set the heading as North , the scanner will trigger an alert if
your current heading is North-east but not if your current heading is due East .)

Edit an existing location

1. Open the
2. Select the type of location you want to edit; the scanner lists the existing locations of that
type in alphabetical order.
3. Select the location you want to edit, then change any of the location settings you want.
This page applies to the following scanner(s):
Users Guide
file:///C|/Documents%20and%20Settings/POpitz/My%20D...emp/CDImage_090515/Manual/ProgrammingLocations.html (3 of 3)5/26/2009 11:12:36 AM
Program Location menu.
BCD996XT BCT15X BCD396XT BC346XT