Uniden BCD996XT User Manual page 951

SearchFor < UnidenMan4 < TWiki
During the wait time, the scanner evaluates the received signal; if it detects P25 data, the
scanner opens squelch immediately. If it does not detect any P25 data, the scanner opens
squelch as soon as the wait time expires.
Note: Any analog transmissions on this channel will lose the first part of
the transmission, up to the wait time you set here.
Select the number of milliseconds (after the start of a transmission) the scanner should
wait while checking for P25 data. Choose a number from 0 through 1000 ms in 100 ms
increments. The scanner only applies the wait time when Tone/Code Search in Srch/
CloCall Opt is set to Off.
Search with Scan
Search and Store
Search a stored system and save the frequency information of any active channels.
Set Search Key
The scanner has three one-touch search keys (number keys 1 , 2 , and 3 ) that you can
assign to any saved search range.
1. Select the search key you want to program ( Search Key 1 through Search Key
3 ).
2. Select the search range you want to assign to this key. The search range can be a
service search, a custom search, a tone-out search, or a band scope search.
3. Press YES to confirm the selection.
Once you assign a search range to a key, you can start the search just by pressing the
appropriate key.
This page applies to the following scanner(s):
Guide
file:///C|/Documents%20and%20Settings/POpitz/My%20Documents/temp/CDImage_090515/Manual/SearchFor.html (6 of 6)5/26/2009 11:16:00 AM
BCD996XT BCD396XT BCT15X Users