Uniden BCD996XT User Manual page 790

<COMMAND GIN>
Get/Set Group Info
Controller → Radio
GIN,[GRP_INDEX][\r]
GIN,[GRP_INDEX],[NAME],[QUICK_KEY],[LOUT],[LATITUDE],[LONGITUDE],[RANGE],
[GPS ENABLE][\r]
Radio → Controller
GIN,[GRP_TYPE],[NAME],[QUICK_KEY],[LOUT],[REV_INDEX],[FWD_INDEX],[SYS_INDEX],
[CHN_HEAD],[CHN_TAIL],[SEQ_NO] ,[LATITUDE],[LONGITUDE],[RANGE],[GPS ENABLE] [\r]
GIN,OK[\r]
For Group Information
[GRP_INDEX]
[GRP_TYPE]
[NAME]
[QUICK_KEY]
[LOUT]
[REV_INDEX]
[FWD_INDEX]
[SYS_INDEX]
[CHN_HEAD]
[CHN_TAIL]
[SEQ_NO]
[LATITUDE]
[LONGITUDE]
[RANGE]
[GPS ENABLE]
Get/Set Group Information.
In set command, only "," parameters are not changed.
The set command is aborted if any format error is detected.
When the system protect bit is ON, except [NAME], [REV_INDEX], [FWD_INDEX],
[SYS_INDEX], [CHN_HEAD], [CHN_TAIL], other parameters will be send as a reserve
parameter in the Radio -> Controller command.
This command is only acceptable in Programming Mode.
: Group Index
: Group Type
: Name
: Quick Key (1-9,0: means 10, .(dot): means none)
: Lockout
: Reverse Group Index of the System
: Forward Group Index of the System
: System Index
: Channel Index Head of the Group List
: Channel Index Tail of the Group List
: Group Sequence Number of the System
: North or South Latitude
: West or East Longitude
: Range
: GPS Location detection
232
(C: Channel Group / T: TGID Group)
(max.16char)
(0:Unlocked / 1:Lockout)
(1-250 : 1= 0.5 mile or km)
(0:OFF/1:ON)