Error Messages - Uniden BCD996XT User Manual

Hexadecimal TGID edit
Turn the [Scroll Control] to select Hexadecimal characters from "0" to "F",
Press [4 / LEFT / ifx] to move the cursor left or press [6 / RIGHT / disp] to move cursor right.
Press [E / yes / gps] to set the Hex ID.
Note: You can change the TGID format in Set ID Format (DEC/HEX)
If you press the decimal key when there are already an acceptable number of hyphens, the TGID is cleared
and the editing cursor moves to the first position.
Note: For details of TGID formats, please see: TGID FORMAT FOR TRUNKED SYSTEM.
If the entered TGID is invalid, the scanner beeps an Error Tone and displays "Bad TGID".
Press any key to return to the editing mode.
Notice of Location Data Input
Use WGS84 (World Geodetic System 1984) for latitude and longitude input.
The acceptable range of latitude and longitude is as follows.

Latitude

Longitude
The actual navigation distance may differ from the calculated one when a latitude exceeding 85 degrees
(either North or South) is used.

Error Messages

If the scanner tries to create a new System/Location/Site/Group/Channel/TGID when it is already at the
limit of System/Group/Channel, it displays "Over Limit". (See: Memory Architecture)
If the scanner tries to create a new System/Location/Site/Group/Channel/TGID when the memory is full, it
displays "Memory Full".
If the scanner tries to create a new System/Location/Site/Group/Channel/TGID when the memory is
broken, it displays "Memory Error". When the scanner displays this message, you must initialize the
memory by pressing [2 / sr2] + [9 / mod] + [Hold /
repair fault if this does not correct the problem.
Thursday, May 14, 2009
Bad TGI D
Press Any Key
: 90º00'00.00 S - 00º00'00.00 N - 90º00'00.00 N
: 180º00'00.00 E - 000º00'00.00 W - 180º00'00.00 W
] while turning on the scanner. The scanner has a
31