Uniden BCD996XT User Manual page 623

Set Alert Light
This option can be used to set Alert Light.
Alert Light Pattern selections.
Off
On
Slow Blink
Fast Blink
Press [E / yes / gps] to accept the entry and return to the previous menu.
Note: This setting menu appears in "Dangerous Xing" and "Dangerous Road".
Set LocationInfo
You use this option to set the location data.
First, you set the latitude.
Press the number keys to enter latitude data. Press any number key when the cursor is in the last position
to toggle between south latitude (S) and the north latitude (N).
Press [E / yes / gps] to go to the longitude setting.
Press the number keys to enter longitude settings. Press any number key when the cursor is in the last
position to toggle between east longitude (E) and west longitude (W).
Press [. / no / pri] to jump to the next input area. For example, press [. / no / pri] on Degree Number for
DMS to jump to the Minute Number. Press this again to jump to the second number. Press [. / no / pri] or
a number key on N/S or W/E to toggle these settings.
Set Range
This option sets the range for a POI.
In this menu, the setting unit depends on the setting in Set Unit.
When you select "mile" in Set Unit the displayed unit will be miles.
When you select "km" in Set Unit the displayed unit will be kms.
The valid setting range is from 0.05 to 4.0, by 0.05 steps.
Press [E / yes / gps] to accept the setting and return to the previous menu.
Note: This setting menu appears only in "POI".
Thursday, May 14, 2009
The alert light will not turn on
The alert light is set to on
The alert light blinks slowly
The alert light blinks fast
65