Care And Maintenance; Resetting The Scanner; General Use; Location - Uniden UBC75XLT Owner's Manual

CARE AND MAINTENANCE

RESETTING THE SCANNER

If the scanner's display locks up or stops operating properly,
you might need to reset the scanner.
CAUTION: This procedure clears all the information
1.
2.

GENERAL USE

•
•
•
•

LOCATION

•
•
UBC75XLT_UB372BV_20130401.indd 51 UBC75XLT_UB372BV_20130401.indd 51
you have stored in the scanner. Before you reset
the scanner, try turning it off and back on to see if
it begins working properly. Reset the scanner only
when you are sure it is not working properly.
Turn off the scanner.
While holding down 2, 9, and Hold, turn on the scanner.
It takes about 5 seconds to initialize and CLEAr appears.
Turn the scanner off before disconnecting the power.
Always write down the programmed frequencies in the
event of memory loss.
If memory is lost, simply reprogram each channel. The
display shows 000.0000 in all channels when there has
been a memory loss.
Always press each button fi rmly until you hear the entry
tone for that key entry.
Do not use the scanner in high-moisture environments
such as the kitchen or bathroom.
Avoid placing the unit in direct sunlight or near heating
elements or vents.
51
2013/04/02 11:08:37 2013/04/02 11:08:37