Uniden BCD996XT User Manual page 295

Edit Name
You can name the site.
Refer to FONT DATA for the characters that can be entered.
Press [E / yes / gps] to accept the name entered. The scanner returns to the previous menu.
Set Quick Key
This option lets you select which Quick Key will rapidly lock/unlock the site in Scan Mode.
Turn [Scroll Control] to select the Site Quick Key. The Site Quick Key can be from "0" to "99" and "."(= Not
assigned).
Press a number key to jump the cursor to the head number of ten's place. For example if you press [2 /
sr2], the cursor jumps to "20".
Press [E / yes / gps] to accept and return to the previous menu.
Set Startup Key
The scanner locks or unlocks the system according to setting of this option by pressing and holding a
number key at power-on or while displaying the Opening Screen.
Turn [Scroll Control] to select the Startup Key in this menu. The Startup Key can be set from "0" to "9" and
"."(= Not assigned).
Press [E / yes / gps] to accept the selection and return to the previous menu.
Edit Band Plan (P25)
This setting menu is shown when the selected system is a P25 Standard Trunked system.
Usually, the scanner stores the plan automatically when it receives the plan from a repeater. Therefore,
you do not have to set the plan in most systems. The plan must be set manually only when the repeater
doesn't send the plan.
You can set 16 bands for a site. First, select the Band Plan number ("Select Plan") by turning the [Scroll
Control]. The scanner displays the Band Plan number, the base frequency and the spacing frequency as
"n:xxx.xxxxx/y.yy". (n : Band Plan number, xxx.xxxxx : the base frequency, y.yy : the space frequency)
Press [E / yes / gps] to select a band plan.
Input the base frequency ("Input Base Freq"). This frequency can be from 25.00000MHz to
1300.00000MHz at 5.0Hz steps. Press [E / yes / gps] to set the base frequency.
Set the space frequency ("Input Spacing"). You can input from 125Hz to 128.0kHz in 125Hz Steps. Press [E /
yes / gps] to finish the band plan setting.
If you enter an out of range value for the base frequency, the scanner displays "Out of Band" and "Press
Any Key" and sounds an Error Tone. Press any key to return to editing mode.
Thursday, May 14, 2009
46