Uniden BCD996XT User Manual page 534

ToneOutMode < UnidenMan4 < TWiki
Tone Out mode
This page applies only to the
see:
With the tone out feature, the scanner monitors up to 10 different channels for paging tones
(two-tone sequential, single tone, and group tone). Normally, the scanner monitors each of
the 10 channels in turn. However, if any tone-out channels share the same frequency,
modulator, and attenuator settings, the scanner checks these channels simultaneously.
Configuring Tone Out channels
To configure Tone-Out channels:
1. Go to the
2. Select Tone-Out Setup .
3. Select the Tone-Out channel ( Tone-Out 1 through Tone-Out 10 ) you want to
configure.
4. Select Set Frequencies and choose the frequencies for this channel
5. Select Set Tone and program Tone A and Tone B.
6. Set any of the other properties as you prefer (they aren't required).
Required
Recommended
file:///C|/Documents%20and%20Settings/POpitz/My%20Documents/temp/CDImage_090515/Manual/ToneOutMode.html (1 of 4)5/26/2009 11:13:54 AM
BCD996XT Tone Out Mode
BCT15X Tone Out Mode
Tone-Out for... menu.
Frequencies ( Set
Tone A and Tone B (
Name ( Edit Name)
BCD396XT and BC346XT. For other models
Frequencies)
Set Tones)