Uniden BCD996XT User Manual page 969

WXOperation < UnidenMan4 < TWiki
Set Delay Time
Set the number of seconds the scanner should wait after a transmission stops before
moving on to the next channel. Select 0, 1, 2 (default), 5, 10, or 30 seconds.
To have scanner leave the channel after a designated number of seconds whether the
transmission stops or not, select one of the negative values. Choose -10 seconds to have
the scanner leave the channel after 10 seconds even if the transmission is still going on;
choose -5 seconds or -2 seconds to have the scanner leave after 5 seconds or 2 seconds,
respectively.
Note that since weather broadcasts are continuous, the scanner does not apply negative
delays. If you select a negative delay in this mode, the scanner will treat it as a 2 second
delay.
Set Attenuator
Turn on attenuation to reduce the signal strength by 20 dB. You can turn on attentuation
for individual frequencies and channels or for entire sites. If you turn on attenuation for a
site, all frequencies within that site will be attenuated.
Set Audio AGC
Turn on Automatic Gain Control (AGC) for this system. When you activate this feature,
the scanner automatically adjusts the volume for each channel based on the signal
strength. You can turn on the gain control for Analog and Digital signals separately.
To change the settings for the audio AGC, see
Set Record (BCD996XT Only)
Turn on this option if you want the weather mode audio to be included on the rear
RECORD OUT jack.
WX Alt Priority
Select On if you want the scanner to check the weather channels in the background
file:///C|/Documents%20and%20Settings/POpitz/My%20Documents/temp/CDImage_090515/Manual/WXOperation.html (3 of 4)5/26/2009 11:16:06 AM
Adjust Audio AGC