Uniden BCD996XT User Manual page 300

Set Modulation
You can select the modulation from following settings.
Auto* The scanner uses the modulation normal for the frequency's band.
NFM The scanner uses Narrowband FM demodulation.
FM The scanner uses FM demodulation.
Press [E / yes / gps] to accept the entry and return to the previous menu.
*If the system type is "MOT","LT" or "EDCS SCAT", when the default modulation of the frequency in Band
Defaults is not FM or NFM, the scanner will operate as FM.
Set Attenuator
You can attenuate RF reception on the frequency.
On The frequency will be attenuated.
Off The frequency will not be attenuated.
Press [E / yes / gps] to accept the selection and return to the previous menu.
Set Lockout
This option allows you to lock or unlock the current system. When the system is locked out, the scanner
does not check it.
Unlocked
Temporary L/O
Lockout
Press [E / yes / gps] to accept the selection and return to the previous menu.
Set Hold Time
In Trunked Systems, this setting is applied only when a Control Channel can be received.
If no Control Channel can be received, the scanner goes to the next system immediately.
You change this setting from 0 to 255 seconds by pressing the number keys.
Press [E / yes / gps] to accept the entry and return to the previous menu.
If you enter over "255" for the Hold Time, the scanner prompts "Out of Range" and "Set Max? (Y/N)".
When [E / yes / gps] is pushed, maximum value 255 will be set.
It returns to the edit state, if you press [. / no / pri].
Thursday, May 14, 2009
The system is unlocked.
The system is temporarily locked out.
The system is locked out.
51