Airbag Assembly Removal - Acura NSX 1997 Service Manual

Table of Contents

Supplemental Restraint System (SRS)

Airbag Assembly Removal

Store a removed airbag assembly with the

pad surface up; if the airbag is improperly stored face

down, accidental deployment could propel the unit with

enough force to cause serious injury.

• Do not install used SRS parts from another car.

When repairing, use only new SRS parts.

• Carefully inspect the airbag assembly before you in-

stall it. Do not install an airbag assembly that shows

signs of being dropped or improperly handled, such

as dents, cracks or deformation.

• Do not disassemble or tamper with the airbag

Before disconnecting any parts of the SRS wire

harness, install the short connectors (RED) (see page

Driver's Airbag:

Remove the two Torx bolts using a Torx T30 bit,

then remove the driver's airbag assembly.

Use a Torx T30 bit

Table of Contents

Passenger's Airbag:

Remove the glove box, then remove the four moun-

ting nuts from the bracket.

Remove the bracket and mounting nut from the

passenger's airbag assembly.

Carefully lift the passenger's airbag assembly out

of the dashboard.

AIRBAG ASSEMBLY

AIRBAG ASSEMBLY

MOUNTING NUTS

Table of Contents