Toner Density Sensor Removal - Lexmark MX310 Service Manual

Toner density sensor removal

1
Remove the left cover. See
2
Remove the main drive gearbox. See
3
Remove the rear door and cover. See
on page 370.
4
Remove the power supply. See
5
Remove the power supply shield. See
6
Remove the duplex. See
7
Disconnect the spring (A) from the printer.
8
Remove the two screws (B).
9
Disconnect the cable from the sensor.
Installation notes:
a
Apply the RheoGel 739 to the top and bottom of the shutter blade extension.
b
Apply the RheoGel 739 to the point of contact between the bracket (A) and cam.
"Left cover removal" on page
"Main drive gearbox removal" on page
"Rear exit door removal" on page 369
"Power supply removal" on page
"Power supply shield removal" on page
"Duplex removal" on page
B
Parts removal
279.
339.
341.
349
281.
and "Rear cover removal"
340.
A
7015