56 Standard Usb Port Disabled; 56 Usb Port <X> Disabled; 57 Configuration Change, Held Jobs Were Not Restored; 58 Too Many Trays Attached - Lexmark 464de - X B/W Laser User Manual

56 Standard USB port disabled

Try one or more of the following:
•
Touch Continue to clear the message.
The printer discards any data received through the USB port.
•
Make sure the USB Buffer menu item is not set to Disabled.
56 USB port <x> disabled
<x> is the number of the USB port.
Try one or more of the following:
•
Touch Continue to clear the message.
The printer discards any data received through the USB port.
•
Make sure the USB Buffer menu item is not set to Disabled.

57 Configuration change, held jobs were not restored

Since the time the jobs were stored on the printer hard disk something has changed in the printer to invalidate the
held jobs. Possible changes include:
•
The printer firmware has been updated.
•
Paper input, output, or duplex options needed for the print job were removed.
•
The print job was created using data from a device in the USB port and the device is no longer in the port.
•
The printer hard disk contains jobs that were stored while installed in a different printer model.
Touch Continue to clear the message.

58 Too many trays attached

1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Remove the additional trays.
4
Connect the power cord to a properly grounded outlet.
5
Turn the printer back on.

58 Too many flash options installed

1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Remove the excess flash memory.
4
Connect the power cord to a properly grounded outlet.
5
Turn the printer back on.
Troubleshooting
264