Setting The Position Of The Top Feed Foot - DURKOPP ADLER 610-10 Service Instructions Manual

Individual settings
2. Loosen both screws of the pusher eccentric (3).
3. Turn the pusher eccentric (3) so that the center of the slot (4) is pointing
4. Tighten both screws of the pusher eccentric (3).

4.15.4 Setting the position of the top feed foot

Proper setting
The top feed foot has been set at the factory in such a way that parallel
support on the feed dog is guaranteed for light to medium-weight sewing
material.
The support surface (inclination) can be adjusted to suit the sewing material.
Disturbance
Property damage
Fig. 62: Setting the position of the top feed foot
(1) - Sliding shaft
(2) - Threaded pins
To set the position of the top feed foot:
1. Loosen the threaded pins (2).
2. Push/pull the pin (3) into or out of the sliding shaft (1).
3. Tighten the threaded pins (2).
Order
After adjusting the inclination of the top feed, check and, if necessary,
correct the stroke height.
Service Instructions 610-10/630-10 - 01.0 - 12/2016
up vertically in position F (12 o'clock).
①
②
This adjusts the inclination of the top feed foot.
③
(3) - Pin
73