Disassembling And Assembling The Looper And Looper Mounting - DURKOPP ADLER 610-10 Service Instructions Manual

3.3.3 Disassembling and assembling the looper and looper mounting

Fig. 12: Disassembling and assembling the looper and looper mounting
①
②
(1) - Screw
(2) - Screw
(3) - Screw (covered)
Disassembling the looper mounting and looper
To disassemble the looper mounting and looper:
1. Slightly loosen screws (1) and (3).
2. Loosen the screw (2).
3. Remove the looper mounting (4) with looper (5) from the shaft.
Assembling the looper mounting and looper
To assemble the looper mounting and looper:
1. Push the looper mounting (4) with looper (5) onto the shaft.
2. Tighten both screws (1) and (3) a little.
3. Tighten the screw (2) on the looper mounting (4).
Order
After assembling the looper and the looper mounting, perform the following
settings:
1. Loop stroke and looper clearance ( p. 54)
2. Needle guard ( p. 62)
24
(4) - Looper mounting
(5) - Looper
Service Instructions 610-10/630-10 - 01.0 - 12/2016
Working basis
⑤
④
③