Setting The Feed Dog Height At Top Dead Center - DURKOPP ADLER 967 Instruction Manual

Setting the feed dog
Setting steps
1. Set the upper stitch length adjusting wheel to the maximum stitch length.
2. Loosen the setscrews (1).
3. Put the handwheel into the 190° position.
4. Press stitch adjustment lever (3) downwards and observe the feed dog
5. Turn the pusher eccentric (2) such that the feed dog and needle no
6. Tighten the setscrews (1).

8.2.2 Setting the feed dog height at top dead center

The feed dog reaches the maximum stroke height at top dead center when
the position of the handwheel is 190°.
Proper setting
Place the feed dog in the uppermost position by turning the handwheel.
 The upper edge of the feed dog protrudes 1.3 mm above the throat
Cover
• Tilt the machine head ( p. 10).
Service Instructions 967 - 02.0 - 12/2015
and needle in the process.
longer move when the stitch adjustment lever (3) is pressed.
WARNING
Risk of injury!
Crushing injuries from moving parts.
Switch off the machine before checking and setting
the feed dog height.
plate.
43