DURKOPP ADLER 610-10 Service Instructions Manual page 30

Proper setting
The largest slot A of the adjusting disk should be in a line with the slot (1)
of the arm shaft crank.
Disturbance
All function sequences are disturbed
Cover
• Disassembling the head cover ( p. 16)
• Disassembling the arm cover ( p. 17)
Fig. 17: Aligning the adjusting disk on the arm shaft crank (2)
(1) - Slot of arm shaft crank
(2) - Upper toothed belt wheel
(3) - Arresting pin
To align the adjusting disk on the arm shaft crank:
1. Remove the toothed belt (5).
2. Loosen the screws on the upper toothed belt wheel (2).
3. Insert the arresting pin (3) into the slot (1) of the arm shaft crank.
4. Turn the handwheel until the arresting pin (4) can be inserted into the
5. Tighten the screws on the upper toothed belt wheel (2).
6. Position the toothed belt (5).
7. Remove arresting pins (3) and (4).
28
①
largest slot A of the adjusting disk ( p. 29).
⑤
② ③
(4) - Arresting pin
(5) - Toothed belt
Service Instructions 610-10/630-10 - 01.0 - 12/2016
Working basis
④