Table of Contents
Advertisement
SERVICE PROGRAM MODE
Mode No.
2
(Class 1, 2, and 3)
964
Bk: Recovery Select
1
970
Oil Removal Mode
1
Oil Removal 1
2
Oil Removal 2
3
Number of Continue
4
Number of Duplex
5
ITB Cleaning Clutch
Off/On Number
980
Dctr Roller Interval
1
Job_Interruption: K
2
Job_Interruption: M
3
Job_Interruption: C
4
Job_Interruption: Y
5
Job_end: K
6
Job_end: M
7
Job_end: C
8
Job_end: Y
Function / [ Setting ]
Selects the toner end recovery mode for black.
[0 ~ 2 / 0 / 1 /step]
0: Quick Mode
1: Long Mode (quiet)
2: Medium Mode
Enables/disables the oil removal process for a multi-
page job.
[0 ~ 1 / 1 / 1 /step]
• 0: Disables
• 1: Enables
Oil on duplex copies gets on the transfer belt, and this
can cause uneven image density. To remove this oil,
printing stops, the PCU turns, and the cleaning unit
removes the oil.
Enables/disables the oil removal process after job end.
[0 ~ 1 / 1 / 1 /step]
• 0: Disables
• 1: Enables
Specifies how many times the oil removal process is
repeated.
[1 ~ 20 / 5 / 1 /step]
The more times the oil removal is repeated, the better
the output images are; but the longer it takes.
Specifies how often the oil removal process is done. The
unit is the number of duplex prints. The counter counts
down once every narrow (A4 SEF or less) duplex sheet,
and counts back up 1 for every other type of sheet.
[1 ~ 50 / 10 / 1 /step]
[0 ~ 5 / 2 / 1 /step]
This SP sets the number of times the ITB clutch is
turned on/off at the end of oil removal mode (SP2-970-
01 - this removes oil from the ITB to ensure uniform
image density). Turning the ITB clutch on/off helps to
remove excess toner that can cling to and then drop
from the edge of the newly added ITB cleaning blade
during oil removal.
Specifies the timing for reversing the doctor roller during
the multiple printing with single color. When this counter
reaches the prescribed value, reversing the doctor roller
is done during the print job.
In addition, reversing the doctor roller is done when the
counter reaches the 1/2 prescribed value in these SPs
after the toner near end has been detected.
[0 ~ 200 / 100 / 10 /step]
0: Disables job interruption.
Specifies the timing for reversing the doctor roller after
job end with single color. When this counter reaches the
prescribed value and next job is not commanded,
reversing the doctor roller is done after the job end.
[1 ~ 100 / 20 / 1 /step]
5-16
10 February, 2005
Advertisement
Table of Contents
