Table of Contents
Advertisement
10 February, 2005
Mode No.
5
(Class 1, 2, and 3)
825
NV-RAM Data Download
1
NV-RAM Data
Download
828
Network Setting
50
1284 Compatibility
(Centro)
52
ECP (Centro)
65
Job Spooling
66
Job Spooling Clear:
Start Time
828
69
Job Spooling
(Protocol)
84
Printing Settings List
90
TELNET
(0: OFF 1:ON)
Function / [ Setting ]
Imports data from an SD card to the NVRAM.
When data has been normally imported into the
NVRAM, a message appears on the operation panel.
After reading the message, turn the main power switch
off and on.
Validates/invalidates IEEE1284 compatibility.
[0 ~ 1 / 1 / 1 /step]
• 0: Invalidated
• 1: Validated
Validates/invalidates ECP.
[0 ~ 1 / 1 / 1 /step]
This SP is activated only when SP5828-050 is set to "1".
• 0: Invalidated
• 1: Validated
Enables/disables Job Spooling.
[0 ~ 1 / 0 / 1 /step]
• 0: Disabled
• 1: Enabled
Enables/disables Job Spooling Clear when the main
power turns on.
[0 ~ 1 / 1 / 1/step]
• 0: ON (Erases the spooled job in the HDD before the
main power is turned off.)
• 1: OFF (Prints the spooled job in the HDD before the
main power is turned off.)
Enables/disables Job Spooling for each protocol.
[0 ~ 1 / 1 / 1/step]
• 0: Enables Job Spooling
• 1: Disables Job Spooling
Bit switch
Bit 0: LPR
Bit 1: FTP
Bit 2: IPP
Bit 3: SMB
Bit 4: BMLinks
Bit 5: DIPRINT
Bit 6: Reserved
Bit 7: Reserved
Prints the settings list related to NCS parameters.
Turns on/ off TELNET.
[0 ~ 1 / 1 / 1 /step]
• 0: OFF
• 1: ON
5-39
SERVICE PROGRAM MODE
Advertisement
Table of Contents
