SKEWED, TRAPEZOID, AND PARALELLOGRAM IMAGES
Action 5-2 Adjusting the original skew when the rear pulling load is larger
Raise the left side of the ADF by adding washers as shown below.
[C]
1. Remove the ADF unit from the copier.
2. Remove the shoulder screw [A].
3. Add one or two washers (P/N 07010050Z [B], t=0.7mm) between the hinge
bracket (mainframe) and ADF left hinge [E] to raise the height of the left side of
the ADF.
4. Add the same quantity of the washers [C] to the neighboring screw hole [D] on
the hinge bracket.
5. Reattach the ADF so that the ADF hinge [E] is positioned horizontal on top of
the washers added to the left hinge bracket.
[A]
[B]
[D]
M03070201.WMF
[B, C]
4-36
10 February 2005
[E]
M03070202.WMF