Table of Contents
Advertisement
10 February 2005
Action
Action 1 (skewed image of trimming pattern)
Image skew when feeding from mainframe Trays 1 and 2 because the operator
does not set the side fence flush against the paper stack.
1. Advise customers that the side fence should be set flush against the loaded
paper stack, or in cases where the customer gives approval, secure the side
fences in places [A] with two screws. Two screws [B] are located on the tray 1
and 2 as shown below.
NOTE: The level of skew will increase twofold if there is a 1mm gap between the
paper and side fence.
2. As a supplement, the level of skew can be further minimized by increasing the
paper buckle in SP1-003. Try adjusting this value several times while checking
the level of skew on the printouts, keeping in mind that a higher value tends to
cause Z-folds and a lower value tends to cause paper jams.
SKEWED, TRAPEZOID, AND PARALELLOGRAM IMAGES
B156T601.JPG
[A]
4-31
[B]
B156T602.JPG
Advertisement
Table of Contents
