FUSING/PAPER EXIT
3.8.6 FUSING LAMPS
1. Oil supply unit (
2. Gear bracket [A] ( x 2)
3. Upper cover [B]
( x 1, shoulder screw x 1)
4. Pull out the lamp (350W) [C] (
x 2).
5. Pull out the lamp (770W) [D] (
x 2, Cable x 1).
NOTE: "350W" and "770W" are
printed on the respective
terminals.
When installing the fusing
lamps
Make sure that you install the lamp in the correct orientation. The beveled terminals
[E] must be at the front of the machine as
shown, and the square terminals [F]
must be at the rear. If not, paper
creasing and/or unsatisfactory fusing can
occur.
3.8.2)
3-32
10 February 2005
[B]
[E]
[A]
B156R262.WMF
[D]
[F]
[C]
B156R263.WMF
B156R264.WMF