Working On Sp Mode Menus - Ricoh TH-C1b Service Manual

10 February, 2005
Copy Window for Test Printing
1) Touch the "Copy Window" button (
window is displayed.
2) Adjust the settings if necessary, and press the  (start) key to make the
test print.
3) Touch the "SP Mode" button (highlighted on the touch screen). The SP
mode screen is displayed.

Working on SP Mode Menus

The SP mode menus are classified in three levels.
1. Find the necessary SP mode menu from the "SP Mode Table" (
2. Select an SP using either of the following two operations:
1) Using the numeric key pad
a) Make sure the "SP Direct" button is highlighted. (If not, touch the button.)
b) Type the SP mode menu number at the numeric key pad.
2) Using the touch screen
c) Touch the "Open All" button or the "Group #" button (where the #
indicates the group number which the necessary menu belongs to).
d) Scroll the menu if necessary (
e) Touch the necessary menu, or touch the "Prev Page" or "Next Page"
button to select the menu.
3. Type the necessary values at the numeric key pad. The value in the input box
is overwritten.
NOTE: 1) "Initial" indicates the default value.
2) To toggle plus/minus, press the  (clear/stop) key.
4. Press the  key. If an out-of-range value has been input in the box, the value
is ignored.
If you are prompted to complete the setting, touch "Yes".
NOTE:
5. Quit the SP mode (
SP Mode Touch Screen). The copy
SP Mode Touch Screen).
Quitting the SP mode).
5-3
SERVICE PROGRAM MODE
5.1.2).
B156S002.WMF
Input box