Table of Contents
Advertisement
10 February, 2005
Mode No.
1
(Class 1, 2, and 3)
105*
11
Heating: OHP/Full
Color
12
Heating: Duplex/1
Color
13
Heating: Duplex/Full
Color
14
Pressure: Idling
15
Pressure: Ready
16
Pressure: Standby
27
Heating: OFFSET +
28
Pressure: OFFSET +
29
Heating: OFFSET –
30
Pressure: OFFSET –
106
Temperature Display
1
Heating Roller
2
Pressure Roller
109
Fusing Nip
1
Execute Mode
2
Stop Duration
Function / [ Setting ]
Sets the heating roller temperature for the OHP sheets
in full-color mode.
[120 ~ 190 / 175 / 1°C/step]
Sets the heating roller temperature for duplex printing
(both sides) in single-color mode.
[120 ~ 190 / 150 / 1°C/step]
Sets the heating roller temperature for duplex printing
(both sides) in full-color mode.
[120 ~ 190 / 155 / 1°C/step]
Sets the temperature at which the pressure roller starts
idling.
[10 ~ 100 / 10 / 1°C/step]
Sets the temperature at which the pressure roller
becomes ready for printing.
[60 ~ 150 / 65 / 1°C/step]
Sets the pressure roller temperature for the ready
(standby) condition. After the main switch has been
turned on, the machine enters this condition when the
pressure roller temperature reaches the temperature
specified in this SP mode. When the machine is
recovering from energy saver or auto off mode, the
machine becomes ready when both heat and pressure
roller temperatures reach the specified temperature.
Heating roller: SP1-105-3
[60 ~ 150 / 115 / 1°C/step]
Sets the heating roller temperature correction for when
room temperature is 15°C or lower.
[0 ~ 20 / 5 / 1°C/step]
Sets the pressure roller temperature correction for when
room temperature is 15°C or lower.
[0 ~ 20 / 0 / 1°C/step]
Sets the heating roller temperature correction for when
room temperature is 30°C or higher.
[0 ~ 20 / 5 / 1°C/step]
Sets the pressure roller temperature correction for when
room temperature is 30°C or higher.
[0 ~ 20 / 0 / 1°C/step]
Displays the current temperature of the heating and
pressure rollers.
Checks the fusing nip width using an OHP sheet.
• The OHP sheet stops in the fusing unit for the
specified time (
SP1-109-2).
• The nip width should be 9 ± 0.5 mm at front and rear.
If this requirement is not met, change the fusing unit.
Adjusts the stoppage time for the OHP sheet in the
fusing unit (
SP1-109-1).
[0 ~ 100 / 10 / 1 s/step]
5-7
SERVICE PROGRAM MODE
Advertisement
Table of Contents
