Procedure To Use The Automatic Clock Adjustment Function; Procedure; Settings Required For Automatic Clock Adjustment - Omron NX-series User Manual

2 Automatic Clock Adjustment
2-2
Procedure to Use the Automatic
Clock Adjustment Function
2-2-1

Procedure

1
Select Controller Setup - Built-in EtherNet/IP Port Settings on the Sysmac Studio.
Set the following on the NTP Settings Display.
• NTP server settings (required)
• NTP operation timing
2
Select Synchronization from the Controller Menu. The built-in EtherNet/IP port settings are
transferred to the Communication Control Unit.
2-2-2

Settings Required for Automatic Clock Adjustment

The following Built-in EtherNet/IP Port Settings are made from the Sysmac Studio to use automatic
clock adjustment.
Tab page
NTP
*1. Required to change from the default value of 123.
*2. Required to change from the default value of 10 seconds.
Additional Information
Make the settings in the NTP Settings Display if automatic clock adjustment is used. Refer to
A-1-4 NTP Settings Display on page A - 8 for information on the NTP Settings Display.
2 - 4
Setting
NTP server clock informa-
tion
Port No.
Server specifying method
IP address
Host name
NTP operation timing
Specify a Time
Specify a time in-
terval
Timeout time
NX-series Communication Control Unit Built-in Function User's Manual (Z396)
Setting conditions
Required.
*1
Specified by user.
Required
One of these must be set, depending on
the Server specification type setting.
Required
One of these must be set.
(Set according to the NTP operation
timing.)
*2
Specified by user.
Reference
page A - 8