Omron NX-series User Manual page 138

8 CIP Message Communications
CIP
status
1F VENDOR_SPECIFIC_ERROR
20 INVALID_PARAMETER
8 - 42
Meaning
status
0102, 2103
0104, 1103
8001
8007
8029
8031
8009
800F
8017
8018
8021
8022
8023
8024
8025
8027
8028
NX-series Communication Control Unit Built-in Function User's Manual (Z396)
Add
An attempt was made to write a constant or
read-only variable.
The specified address and size exceed a
segment boundary.
An internal error occurred. (An information
inconsistency was detected in the interface
in the Module.)
An inaccessible variable was specified.
A region that all cannot be accessed at the
same time was specified for SimpleData-
Segment.
An internal error occurred. (A memory allo-
cation error occurred.)
A segment type error occurred.
There is an inconsistency in data length in-
formation in the request data.
More than one element was specified for a
variable that does not have elements.
Zero elements or data that exceeded the
range of the array was specified for an ar-
ray.
A value other than 0 and 2 was specified
for an AddInfo area.
•
The data type that is specified in the re-
quest service data does not agree with
the tag information.
•
The AddInfo Length in the request serv-
ice data is not 0.
An internal error occurred. (An illegal com-
mand format was used.)
An internal error occurred. (An illegal com-
mand length was used.)
An internal error occurred. (An illegal pa-
rameter was used.)
An internal error occurred. (A parameter er-
ror occurred.)
•
An attempt was made to write an out-of-
range value for a variable for which a
subrange is specified.
•
An attempt was made to write an unde-
fined value to an enumeration variable.
Cause