Bowflex LateralX LX3 Service Manual page 51

6. Remove the Mast Endcap and set it aside. Disconnect the Mast Cables
from the Console Cables.
NOTICE: Do not crimp the cables. Do not allow the cables to fall down
into the Console Mast.
7. Using a 6mm hex wrench, remove the indicated hardware. Carefully
remove the Static Handlebar and disconnect the cables. Set the Static
Handlebar and hardware aside for reassembly.
Tie the other piece of string to the Mast Cable ends at the Static Handle-
X4
bar mount.
8. Hold the ends of the Mast Cables at the top of the Console Mast and
carefully pull them out of the Console Mast so that the strings extend
through the mast and out of the base and the Static Handlebar mount.
Note: The red line is the 11Pin cable, the orange line is the 9Pin cable,
and the blue line is the 4Pin cable.
Base
Top
9. Untie the strings from the old
Mast Cables, and tie those string
ends to the corresponding ends
of the new Mast Cables. Use the
strings to pull the new cables care-
fully through the Console Mast.
NOTICE: Do not crimp the cables.
51