Table of Contents
Advertisement
4. Using a 10mm hex wrench, remove the indicated Screws (by arrow)
and remove the Handlebar Links.
X2
5. Using a #2 Phillips screwdriver, remove the 6 indicated screws (ovals
and arrows) from the Upper Shrouds. Use a flathead screwdriver to sepa-
rate the Shrouds at the push fasteners. Remove the Shrouds and Mast
Gasket, and set them safely aside.
X6
6. Disconnect the cables from the Engine Assembly and the Console Mast
cables. Using a 6mm hex wrench, remove the indicated screws and wash-
ers (arrows). Remove the Console Mast assembly.
NOTICE: Do not crimp the cables. This step may require two people.
X4
35
Hide quick links:
Advertisement
Table of Contents
