Bowflex LateralX LX3 Service Manual page 47

22. The remaining assembly steps are the reverse procedure.
Note: P ut the Left Upper Shroud in position first. Align the Right
Upper Shroud with the Push Fasteners and move the Right
Shroud into position. Push the Shrouds together so that the
Push Fasteners are fully seated. Using a #2 Phillips screw-
driver, install the 6 screws. Re-install the Mast Gasket.
Be sure the Handlebar Links are tilted forward. Put the Wave
Washers on the pivot rods.
Be aware that the Handlebar Arms are top heavy, and
will want to pivot when attached onto the Pivot Rod. Be
sure to stay out of the path of the Handlebar.
Align the Handlebar Arm assembly with the pivot rod and
attach the lower Handlebar Arm to the Handlebar Link
23. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
47