Table of Contents
Advertisement
29. Put the Left Mid Pedal Arm back on the Crank and move the Swing
Arm end into the Mid Pedal Arm bracket. Using two 8" or longer adjustable
wrenches (or M24 socket wrench and 24mm box wrench), install the
indicated screw and nut. Fully tighten the nut.
30. Secure the Mid Pedal Arm to the Crank using the indicated screw and
washer. Use a 13mm socket or wrench to tighten securely.
Install the Endcap.
31. Repeat steps 25-26 for the Right Mid Pedal Arm.
32. The remaining assembly steps are the reverse procedure.
Note: P ut the Left Upper Shroud in position first. Align the Right
Upper Shroud with the Push Fasteners and move the Right
Shroud into position. Push the Shrouds together so that the
Push Fasteners are fully seated. Using a #2 Phillips screw-
driver, install the 6 screws. Re-install the Mast Gasket.
Be sure the Handlebar Links are tilted forward. Put the Wave
Washers on the pivot rods.
Be aware that the Handlebar Arms are top heavy, and
will want to pivot when attached onto the Pivot Rod. Be
sure to stay out of the path of the Handlebar.
Align the Handlebar Arm assembly with the pivot rod and
attach the lower Handlebar Arm to the Handlebar Link
33. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
32
Hide quick links:
Advertisement
Table of Contents
