Table of Contents
Advertisement
Accent Light Replacement (Linear)
Replacement of the fireplace accent lights can be performed with a
few simple steps. The accent lights are located beneath the burner.
We recommend that if you need to replace one light, that you replace
them all at the same time. Another option would be to replace them
at the same time as your annual service.
1). Disconnect the electrical and gas supply to the unit.
2). Remove the door / safety barrier from the unit.
3). Remove the burner assembly.
4). There are 5 light bulbs in this appliance. They are removed by
pulled them straight up out of their receptacles. New bulbs can
be bought at most national hardware stores or through your
Montigo dealer. See specs page for information on bulbs. If you
supply your own bulbs, do not use greater than 20 watt bulbs.
5). When installing the new bulbs, try to not contaminate the bulb
with your hands. Using gloves or some type of paper during
installation will help to prolong the life of the bulb.
XG0523 - 170223
Figure 10.0
Accent Light Replacement (Traditional)
Replacement of the fireplace accent lights can be performed with a few
simple steps. The accent lights are located at the top of the fireplace
near the front on either side. Although they can be changed without
removing any components, it would be easier to remove the Fireplace
Panels and Upper Retaining Clip.
We recommend that if you have a need to replace one bulb, you replace
them all at the same time. Another option would be to replace them
at the same time as your annual service.
1). Disconnect the electrical and gas supply to the unit.
2). Remove door and safety screen barrier from the unit.
3). See the section on Fireplace Panel Installation for information on
how to remove the Panels. Once they have been removed, the
Upper Panel Retainers can be removed.
4). To remove a bulb, pull it out of it's socket. New bulbs can be
bought at most national hardware stores or through your
Montigo fireplace dealer. See specs page for information on
bulbs. If you supply your won bulbs, do not use greater than 20
watt bulbs.
5). Replace the Upper Panel Retainers and Firebox Liners.
Operation
Figure 10.0
Figure 10.0
39
Advertisement
Table of Contents
