Table of Contents
Advertisement
Offset Faceplate Installation
When the standard faceplate is used the install width of the fireplace is
30 inches. If your install is smaller than 30 inches, you can use the offset
kit, which will allow you to decrease the install size to 28 inches. This
can only be done with the standard faceplate kit. You must install the
offset kit on the standard faceplate before installing it on the appliance.
Figure 5.12a Standard Faceplate Offset Kit Contents
1. Unpack the standard faceplate kit. Take the rear faceplate and
cut 5/16 inches away from the wire pass-through hole at the
bottom right hand corner.
Figure 5.12a Cutting away excess material
XG0528 - 170223
2. Take the offset faceplate and peel the red protective plastic off of
the self-adhesive tape.
Figure 5.12b Peeling self-adhesive tape
3. Place the rear panel from the standard faceplate over top of
the offset trim. Press down on the adhesive to guarantee good
adhesion.
4. Continue to standard faceplate installation section for remainder
of installation.
Installation
Figure 5.12c
Figure 5.12d
19
Advertisement
Table of Contents
