Table of Contents
Advertisement
4. Carefully slide the right panel along the right side of the firebox
leaving enough room to slide the rear panel behind it. Take care
to not scratch the firebox paint.
5. Carefully slide the right panel along the right side of the firebox
leaving enough room to slide the rear panel behind it. Take care
to not scratch the firebox paint.
6. There is a securing hole
in the bottom of the side
panels. Using one of the
supplied screws, secure
the side panel to the
bottom panel retainer.
You may need to push the
panel back into the firebox
to get the holes to line up.
Figure 8.10
XG0528 - 170223
Figure 8.8
Figure 8.9
7. Slide the left panel into the
firebox until it touches the
rear panel. Secure with
the supplied screw into
the bottom panel retainer.
If needed, push the top
panel retainers in with a
screw driver to keep the
panels tight against the
firebox.
Figure 8.11
34FID Traditional Log Installation
The unit uses high definition cast ceramic logs for exceptional realism.
The ceramic is fragile and can easily scuff or chip the logs. The inside of
the logs are purple so you want to take care to not damage them. Each
log has specific details for correct log placement such as pins, posts or
embers to line up with. Follow the images provided to ensure proper
operation and flame pattern.
1.
Inspect the logs as received for any shipping or handling
damage.
1
3
2.
Take the largest log from the kit and place it on the correct log
rest on the left hand side, and locator pin on the right hand side.
Installation
2
4
5
6
Figure 8.12
Figure 8.13
25
Advertisement
Table of Contents
