Table of Contents
Advertisement
Swing the Door away from the unit, lift over the retaining tabs on top
of the firebox. Be careful to not roll the gasket up off the glass when
reinstalling the door. Installation is the reverse of removal.
Check that the door retainers are properly engaged. If they are not the
door relief system may not operate properly. This can cause a risk of
injury or improper operation of the appliance.
Figure 4.1 Door removal
WARNING
When installing the fireplace - gas lines, accessories or any other
objects cannot impede the proper movement of the door buckles.
12
Propane Conversion
The unit is available in Natural Gas or Liquid Propane versions. If you have
a Natural Gas unit and would like to burn Propane you can purchase an
optional Propane conversion kit and install it using the following steps.
To convert the unit to Propane, the unit must be disconnected from
any gas supply, disconnected from any electrical supply and batteries
and removed from any installation cavity.
The 6 major items that need modification to convert a unit to Propane:
1. Variable regulator on the
gas valve
2. The main burner orifice
3. The pilot burner orifice
4. Set minimum primary air
tab
5. Label on the valve showing
the new specifications
6. Gas fitter conversion label
Tools required:
1. Torx T20 Screw Driver Bit
2. 3/8" Socket Driver
3. 5/32" Allen Key
4. Needle Nose Pliers or Small Flat Head Screw Driver
Converting the gas regulator on the
valve
1. On the right side (control side) of the unit, remove 2 screws that
enable the valve to swing away from the unit.
Figure 4.2 Propane conversion kit showing pilot orifice, main burner orifice,
Installation
Figure 4.1 Propane conversion kit showing
pilot orifice, main burner orifice, Propane
stepper motor, zap strap and gas fitter
conversion label.
XG0528 - 170223
Advertisement
Table of Contents
