Table of Contents
Advertisement
Levelling the Unit
This unit has 4 leveling screws, 2 located inside the rear of the firebox
and 2 located at the bottom front of the Rear Faceplate. Once the unit is
in position, you can use a Phillips screw driver or Slotted screw drivers
to adjust each leveling screw as required.
1. Remove burner, see section on burner removal and install
2. Rear leveling screw adjustment (Linear burner version shown)
3. Front leveling Screw adjustment (Linear burner version shown)
4. Reinstall the burner.
Connecting Power
Please refer to the specification for power supply requirements. This
appliance is supplied with a Power Cord located on the right side of the
appliance. It can be connected directly to a standard electrical outlet.
WARNING
Electrical Grounding Instructions
This appliance is equipped with a three-prong rounding plug for your
protection against shock hazard and should be plugged directly into
a properly grounded three prong receptacle, Do not cut or remove
grounding prong
XG0528 - 170223
Figure 7.
Figure 7.1
Battery Installation / Replacement
The unit uses 2 different sets of Batteries. The Control Backup uses 4x
AA batteries to continue operations during power outages. The Remote
Control uses 3x AAA Batteries for general operation. The Control Backup
Batteries should be changed on a regular basis regardless of if they
have been used or not so that in the event of a power failure, you will
continue to have an operational heating appliance. To replace the
Controller Backup Batteries, remove the Front Faceplate and remove
and re-install new batteries into the Battery Holder located just above
the main Control Board.
Firestones or Fireglass Installation
If your fireplace has already been in operation, disconnect the gas and
electrical supply, remove the door and safety barrier.
1. Open the 9lbs of glass media purchased from your Montigo
Dealer. You only need 8lbs - remove approximately 1lb.
2. Do not drop any glass media into the pilot. To protect the pilot
when installing the glass media, place a piece of tape over the
pilot opening. Remove tape when media installation is complete
and before operating the unit.
Figure 7.3
Installation
Figure 7.2
Figure 7.4
21
Advertisement
Table of Contents
