Table of Contents
Advertisement
6. Remove the 2 screws that
secure the pilot assembly
and ground wire to the
floor of the firebox.
Figure 10.23
8. Remove the screws
securing the valve
mounting bracket. Swing
valve out. Disconnect the
pilot line from the bottom
of the gas valve.
Figure 10.25
10. Feed the 2 electrical lines
from the control board to
the side of the unit.
Figure 10.27
44
7. Remove the 2 screws
securing the pilot bulk
head plate and gasket to
the firebox wall.
Figure 10.24
9. Remove the 2 screws
securing the top of the
control mounting bracket
to the outer shell of the
fireplace.
Figure 10.26
11. From the inside of the
firebox, pull the pilot
assembly, bulk head plate,
gasket and 3 lines through
the firebox and out of the
unit. Leave the ground
wire in the firebox.
Figure 10.27
12. Install the replacement Components in the reverse order, through
the Firebox wall. Install the Pilot Assembly Bracket to the Firebox
floor with 2 screws. Pass the wires through rubber gasket. Make
sure the pilot gas line goes through the far right hole of the gasket
and the cuts in the gasket face up. Make sure that the Ground
Wire, Star Washer and screw are assembled to the bottom of the
Pilot Mounting Bracket as shown in the picture below.
13. Using a round object, like a socket wrench, loop the excess pilot
line into a coil. Be very careful to not kink the line.
15. Attach the Pilot line back into the valve, being very careful not to
over-tighten the line.
16. Feed the 2 electrical wires in between the shell of the unit and
the Control Board and plug them into the appropriate terminals
on the control board.
17. Tie up excess wires and zap strap. Take care to not pinch or kink
wires and pilot gas line.
18. Reverse these steps for reinstallation. Re-connect Gas and
Electrical supply.
Operation
Figure 10.28
Figure 10.29
Figure 10.30
XG0523 - 170223
Advertisement
Table of Contents
