Table of Contents
Advertisement
Remote Operation
The Proflame 2 System consists of the following elements:
1. Pilot Assembly
2. Proflame Gas Valve.
3. Proflame 2 Control Module
4. Wiring Harness
5. Variable Speed fans (If applicable)
7. Proflame 2 remote control
8. Battery Pack
9 Manual override switch
NOTE: Can not be used with home automation systems.
The Proflame 2 Transmitter controls the following
fireplace functions
(all functions may not be available)
1. Main Burner On/Off
2. Main Burner flame modulation (6 levels).
3. Choice of standing or intermittent pilot (CPI/IPI).
4. Thermostat and Smart thermostat functions.
6. Fan speed modulation (6 levels).
The Proflame 2 Transmitter uses a streamlined design with a
simple button layout and informative LCD display. A Mode Key is
provided to index between the features and a Thermostat Key is
used to turn On/Off or index through Thermostat functions, see
Figure 27. Additionally, a Key Lock feature is provided.
WARNING
Do not expose remote control to temperatures below 0°C (32°F) or
above 50°C (122°F)
CAUTION
Property Damage Hazard. Excessive heat can cause property damage.
The appliance can stay lit for many hours. Turn off the appliance if it is
not going to be attended for any length of time.
WARNING
Battery operated device. Read the battery instructions before
installing them into the system. Do not expose any battery, or its
holder, or a device in which batteries are installed, to a working
temperature greater than 54°C / 129°F
XG0523 - 170223
:
Blue Back lit LCD display
Figure 9.8 Proflame 2 Remote
SW1
LED1
SW1 = Programing Button
LED1 = Red Diagnostic Light
LED2 = Amber Programing Remote Control Light
Figure 9.9 Proflame 2 Control Module
Transmission
Thermostat
On/Off/State
Set Point
Temperature/Level/State
Flame On
Fans
Figure 9.10 Remote Control LCD Display
Operation
On/Off Key
Thermostat Key
Up/Down Arrow Key
Mode Key
LED2
Key lock
Low battery alarm
Room
Temperature
CPI mode
(optional)
Not Used
Accent lights
Not used
33
Advertisement
Table of Contents
