Fan Speed Control; Accent Light Control - Montigo H42DF Installation & Maintenance Manual

H*38DF Gas Fireplace
Section:
Disabling Thermostat
Some jurisdictions and bedroom installations require the
thermostat to be disabled.
1. Partially take out one battery, see Figure 42.
2. Insert the battery while holding down the thermostat button.
The remote screen will display 'Clr' while the button is held
down. See Figure 43.
3. To enable thermostat repeat steps 1-2. The remote screen
will display 'set' while the thermostat button is held down.
Figure 42.
Figure 43.
Page 38
Operation

Fan Speed Control

The fireplace is equipped with optional hot air circulating fans.
The speed of the fans can be controlled by the Proflame system.
The fan speed can be adjusted through six (6) speeds. To
activate this function use the Mode Key, see Figure 35, to index
to the fan control icon, see Figure 44. Use the Up/Down Arrow
Keys to turn on, off, or adjust the fan speed. A single "beep" will
....
confirm reception of the command.
.....
Figure 44. Fan Speed Control

Accent Light Control

If the fireplace is equipped with variable accent lights. The
accent light function controls the Accent Lights. To activate this
function use the Mode Key, see Figure 32, to index to the accent
light icon, see Figure 45.
Pressing the Up Arrow Key will turn the light on at the lowest
setting. Continue pressing up to get brighter. Pressing the
Down Arrow Key will turn the lights down until you get to the
off position. A single beep will confirm the reception of the
command.
Figure 45. Light Control
XG0147 - 151123