Table of Contents
Advertisement
7.1 Parameter Definition
Parameters are divided into five groups which are shown as follows. The first character
after the start code P is the group character and the second character is the parameter
character. As for the communication address, it is the combination of group number along
with two digit number in hexadecimal. The definition of parameter groups is as the
followings:
Group 0: Monitor parameters
Group 1: Basic parameters
Group 2: Extension parameters
Group 3: Communication parameters (example: P3-xx)
Group 4: Diagnosis parameters
Abbreviation of control modes:
PT: Position control mode (command from external signal)
S:
Speed control mode
T:
Torque control mode
Explanation of symbols (marked after parameter)
(★)
Read-only register, such as P0-00, P0-01, P4-00.
(▲)
Setting is invalid when Servo On, such as P1-00, P1-46, and P2-33.
()
Not effective until re-power on or off the servo drive, such as P1-01 and P3-00.
()
Volatile parameters, such as P2-31 and P3-06.
Revision May, 2018
Chapter 7 Parameters
(example: P0-xx)
(example: P1-xx)
(example: P2-xx)
(example: P4-xx)
7-1
Advertisement
Table of Contents
Troubleshooting
