Inspection Of Accelerator Pedal Position Sensor - Mitsubishi 6M60-TL Service Manual

<Fuel temperature sensor (outlet)>
• Measure the resistance between terminals 1 and 2.
Standard value
• If any measurement is out of specification, replace the sensor.

#324 Inspection of accelerator pedal position sensor

[Inspection]
• Apply 5 V DC to terminals 4 and 6 and terminals 1 and 3 of the
accelerator pedal position sensor connector.
• Measure the output voltage at terminals 5 and 6 (sensor 1) and
the output voltage at terminals 2 and 3 (sensor 2) with the lever
in each specified position.
Idling position A
Standard value
Accelerator pedal switch
operating position B
Full load position C
A: Position in which accelerator pedal switch is fully pushed in
by lever
B: Position at which continuity between terminals 1 and 2 of ac-
celerator pedal switch connector disappears as accelerator
pedal is pushed downward
C: Position in which lever is touching stopper bolt
• If any output voltage is out of specification, make an adjustment.
• If any output voltage is still out of specification when you have
made an adjustment, replace the sensor.
[Adjustment]
• To adjust the output voltage for the accelerator pedal switch op-
erating position A, use nut D.
• To adjust the output voltage for the full load position C, loosen
nut E and make the adjustment using the stopper bolt.
• After making the adjustment, lock the stopper bolt in position
with the nut.
20°C
80°C 0.318 ± 0.01 kΩ
110°C 0.1417 ± 0.01 kΩ
Lever position Output voltage
13E
+0.14
2.45 kΩ
–0.13
0.85 ± 0.1 V
1.0 ± 0.2 V
4.15 ± 0.1 V
13E-49