Mold Depth Between Segments; Inspection: Overrunning Clutch; Assembly: Front Bearing - Mitsubishi 6M60-TL Service Manual

#930 STARTER
Assembly procedure
54-24

(6) Mold depth between segments

• If the measurement is lower than the specified limit, rectify or re-
place the armature.
• To rectify the armature, grind the illustrated portions.
• If the mold is worn as illustrated, rectify or replace the armature.
: Acceptable
X : Unacceptable

Inspection: Overrunning clutch

If the following inspections reveal any abnormality, replace the
overrunning clutch.
• Turn the shaft in direction B and check that it rotates smoothly.
• Turn the shaft in direction A and check that it locks.

Assembly: Front bearing

• Press-fit the front bearing using
• After the press fitting, caulk the front bearing using the claws on
–A.
CAUTION
• Avoid re-caulking previously caulked points.
–A and –B.