Mitsubishi 6M60-TL Service Manual page 329

AIR DRYER
Lubricant and/or sealant
Mark
O-ring
Adjusting screw (entire surface except thread)
Outer periphery of piston and O-ring groove
Body (inside surface)
Plug thread
Silencer thread
Installation procedure
61-24
Points of application
• Turn the adjusting screw to achieve the indicated dimension
• Install the filters with their soft layers facing the desiccant.
• Place the desiccant in the case, then settle the desiccant by tap-
Specified lubricant and/or sealant
Multipurpose grease
[NLGI No. 2 (Li soap)]
ThreeBond 1110B
ThreeBond 1401B
Adjustment: Adjusting screw
from the top of the upper spring seat to the bottom of the lower
spring seat. Doing so will facilitate the threshold pressure adjust-
ment to the specified value.
Installation: Filters, desiccant, and filter plate
ping gently and evenly around the case with a plastic hammer.
Quantity
As required
As required
Three threads
from the end of
thread